Abrasion Resistance and Impact Steel Plate

The quenched and tempered Steel Plate designed for abrasion resistance and impact. This plate can be used for all material handling equipment. NM400 is 3 to 4 times harder than ordinary structural plate and is easily weldable and can be formed and machined.

NM400 is available in thicknesses from 1/8" to 4", it can be cut by gas, abrasive water jet, laser, or plasma.

Chemistry %

C .12/.16

Mn (Max) 1.55

P (Max) 0.025

S (Max) 0.005

Si .35/.55

Ni (Max) 1.00

Mo (Max) 0.55

Cr (Max) 0.55

B .0005/.005

Mechanical Properties:

Hardness 360 to 444 BHN

Yield Strength 140 ksi

Tensile Strength 180 – 200 ksi

Elongation 15 – 16%

Welding Procedures:

Preheating is recommended. E7018 or E8018 electrode rod or wire meeting AWS specifications.

Suggested Uses for HP Abrasion Resistant Wear Plate:

Bark Hammers Bins & Hoppers Blst Furnace Handling Equipment

Blades Blow Tank Plates Buckets & Components

Bucket Lips Chip Silo Components Chipper Hoods & Components

Chutes Conveyors & Liners Crusher Components

Cyclones Dozer Blade Liners Debarking Crum Components

Downcomer Spout Liners Drag Conveyors Drums & Sprockets

Dust Collector Systems Flights Fan Blades & Housings

Flatback Elbows Flume Liners Hammers

Hell Pads Hammer Mill Side Liners Haul Truck Bed Liners

Hooks Impact Plates Liner Plates

Log Decks Mine Cars & Equipment Hot & cold Strip Mill Guides

Pyrite Liners Sand Systems Scraper Blades

Screens Screw Conveyors Scrap Handling Equipment

Shakeout Machines Shot Blast Equipment Skip Cars

Skirtboard Liners Sprockets Transitions

Washers Wear Plates

An abrasion resistant, quenched and tempered, high strength, fine grained steel wear plate and Abrasion Resistant Wear Plate offers low cost wear protection. With a hardness of 250 to 320 BHN, it will outlast hot rolled carbon plate but can still be drilled, punched, or machined for liners and wear plates. Strength characteristics of this plate make it an excellent choice for structural use. This plate is also referred to as [T-1."

HP is available in thicknesses from 3/16" to 3"

HP may be cut by gas, plasma, laser or abrasive water jet.

Chemistry %

C 0.15 – 0.35

Mn .7 – 1.00

Mechanical Properties:

Hardness 250 to 321 BHN

Yield Strength 100,000 KSI (Minimum)

Tensile Strength 110,000 to 130,000 KSI